US Bridges

Lexington RD over Milners Fork

PoorPosted for load

Preble County, Ohio · .60 E of Ware RD · Structure no. 6830420

Built
1910
115 years old
Condition
Poor
inspected July 2024
Type
Stringer/Multi-beam or Girder
Steel
Length
35 ft
1 main span
Daily traffic
2,340
2015 count
Owner
County
County Highway Agency

About this bridge

Lexington RD over Milners Fork is a steel stringer/multi-beam or girder carrying Lexington RD over Milners Fork in Preble County, Ohio. It was built in 1910, so it is 115 years old, older than the Ohio average of 47.3 years.

The most recent inspection reported to the Federal Highway Administration rates it in poor condition with a lowest component rating of 4 out of 9. The lowest-rated primary component is rated 4 or below, indicating advanced deterioration. Poor does not mean unsafe; such bridges are inspected more often and may carry load restrictions. Its operating status is: posted for load restriction.

It carries about 2,340 vehicles a day, roughly 8% of them trucks, projected to reach 3,248 by 2035. The structure is 35 ft (10.7 m) long and 37 ft wide. If it were closed, the detour would be 3.7 mi (6 km).

CarriesLexington RD
CrossesMilners Fork
Location.60 E of Ware RD
RouteCounty Highway C0056
StateOhio
Coordinates39.75896, -84.54661
Functional classRural Minor Collector

Condition and inspection

Poor

The lowest-rated primary component is rated 4 or below, indicating advanced deterioration. Poor does not mean unsafe; such bridges are inspected more often and may carry load restrictions.

ComponentRatingMeaning
Deck4 PoorAdvanced section loss, deterioration, spalling or scour.
Superstructure4 PoorAdvanced section loss, deterioration, spalling or scour.
Substructure4 PoorAdvanced section loss, deterioration, spalling or scour.
Channel and channel protection5 FairAll primary structural elements are sound but may have minor section loss, cracking, spalling or scour.
Last inspectionJuly 2024
Inspection intervalevery 12 months
Operating statusPosted for load restriction
ScourFoundations stable; scour within limits of footing or piles
Structural evaluation4: Meets minimum tolerable limits to be left in place as is
Deck geometry5: Somewhat better than minimum adequacy to tolerate being left in place as is
Waterway adequacy6: Equal to present minimum criteria
Approach roadway alignment6: Equal to present minimum criteria
Operating rating28.5 US tons
Inventory rating17.9 US tons

Structure

MaterialSteel
DeckCorrugated steel
Main spans1
Design loadHS 15
Structure length35 ft (10.7 m)
Longest span31 ft (9.4 m)
Deck width37 ft (11.2 m)
Roadway width37 ft (11.2 m)
Vertical clearance over deckUnrestricted

Traffic and service

Average daily traffic2,340 (2015)
Projected traffic3,248 by 2035
Trucks8%
Lanes on structure2
Traffic directionTwo-way traffic
CarriesHighway
CrossesWaterway
Detour if closed3.7 mi (6 km)
TollOn a free road
National Highway SystemNo

Ownership and planned work

OwnerCounty Highway Agency
Maintained byCounty Highway Agency
Historic statusNot eligible for the National Register of Historic Places
Work proposedNone recorded
Estimated improvement cost—
NavigationNo navigation control on waterway

Frequently asked questions

When was Lexington RD over Milners Fork built?

It was built in 1910, making it 115 years old in 2025.

What condition is Lexington RD over Milners Fork in?

The National Bridge Inventory rates it in poor condition. The lowest-rated primary component is rated 4 or below, indicating advanced deterioration. Poor does not mean unsafe; such bridges are inspected more often and may carry load restrictions. The last reported inspection was in July 2024.

How much traffic does Lexington RD over Milners Fork carry?

About 2,340 vehicles per day (2015 count), of which roughly 8% are trucks.

How long is Lexington RD over Milners Fork?

The structure is 35 ft (10.7 m) long with a longest span of 31 ft (9.4 m) and a deck 37 ft wide.

Who owns Lexington RD over Milners Fork?

It is owned by the County Highway Agency.