US Bridges

FAP 32 over Clinch River

Good

Grainger County, Tennessee · 3.6 M NW of SR131 · Structure no. 29SR0320007

Built
2009
16 years old
Condition
Good
inspected April 2024
Type
Stringer/Multi-beam or Girder
Prestressed Concrete Continuous
Length
617 ft
6 main spans
Daily traffic
8,247
2021 count
Owner
State
State Highway Agency

About this bridge

FAP 32 over Clinch River is a prestressed concrete continuous stringer/multi-beam or girder carrying FAP 32 over Clinch River in Grainger County, Tennessee. It was built in 2009, so it is 16 years old, younger than the Tennessee average of 47.4 years.

The most recent inspection reported to the Federal Highway Administration rates it in good condition with a lowest component rating of 7 out of 9. All primary components (deck, superstructure, substructure, or culvert) are rated 7 or higher. No significant problems were noted.

It carries about 8,247 vehicles a day, roughly 10% of them trucks, projected to reach 13,195 by 2042. The structure is 617 ft (188 m) long and 87 ft wide. If it were closed, the detour would be 60.3 mi (97 km).

CarriesFAP 32
CrossesClinch River
Location3.6 M NW of SR131
RouteU.S. Route 25
Coordinates36.40113, -83.4583
Functional classRural Principal Arterial - Other

Condition and inspection

Good

All primary components (deck, superstructure, substructure, or culvert) are rated 7 or higher. No significant problems were noted.

ComponentRatingMeaning
Deck7 GoodSome minor problems.
Superstructure7 GoodSome minor problems.
Substructure7 GoodSome minor problems.
Channel and channel protection7 GoodSome minor problems.
Last inspectionApril 2024
Inspection intervalevery 24 months
Operating statusOpen, no restriction
ScourFoundations stable; scour above top of footing
Structural evaluation7: Better than present minimum criteria
Deck geometry9: Superior to present desirable criteria
Waterway adequacy8: Equal to present desirable criteria
Approach roadway alignment8: Equal to present desirable criteria
Operating rating79.3 US tons
Inventory rating35.7 US tons

Structure

MaterialPrestressed Concrete Continuous
DeckConcrete, cast-in-place
Main spans6
Design loadHL 93
Structure length617 ft (188 m)
Longest span105 ft (32 m)
Deck width87 ft (26.5 m)
Roadway width85 ft (25.9 m)
Vertical clearance over deckUnrestricted

Traffic and service

Average daily traffic8,247 (2021)
Projected traffic13,195 by 2042
Trucks10%
Lanes on structure4
Traffic directionTwo-way traffic
CarriesHighway
CrossesWaterway
Detour if closed60.3 mi (97 km)
TollOn a free road
National Highway SystemYes

Ownership and planned work

OwnerState Highway Agency
Maintained byState Highway Agency
Historic statusHistorical significance not determinable at this time
Work proposedNone recorded
Estimated improvement cost—
NavigationNo navigation control on waterway

Frequently asked questions

When was FAP 32 over Clinch River built?

It was built in 2009, making it 16 years old in 2025.

What condition is FAP 32 over Clinch River in?

The National Bridge Inventory rates it in good condition. All primary components (deck, superstructure, substructure, or culvert) are rated 7 or higher. No significant problems were noted. The last reported inspection was in April 2024.

How much traffic does FAP 32 over Clinch River carry?

About 8,247 vehicles per day (2021 count), of which roughly 10% are trucks.

How long is FAP 32 over Clinch River?

The structure is 617 ft (188 m) long with a longest span of 105 ft (32 m) and a deck 87 ft wide.

Who owns FAP 32 over Clinch River?

It is owned by the State Highway Agency.