US Bridges

RTE 22 over Factory Hill Road Wallo

Good

Rensselaer County, New York · 0.2 MI S JCT Rts 67 & 22 · Structure no. 000000001017000

Built
2018
7 years old
Condition
Good
inspected May 2024
Type
Stringer/Multi-beam or Girder
Steel Continuous
Length
279 ft
2 main spans
Daily traffic
4,783
2018 count
Owner
State
State Highway Agency

About this bridge

RTE 22 over Factory Hill Road Wallo is a steel continuous stringer/multi-beam or girder carrying RTE 22 over Factory Hill Road Wallo in Rensselaer County, New York. It was built in 2018, so it is 7 years old, younger than the New York average of 53 years.

The most recent inspection reported to the Federal Highway Administration rates it in good condition with a lowest component rating of 9 out of 9. All primary components (deck, superstructure, substructure, or culvert) are rated 7 or higher. No significant problems were noted.

It carries about 4,783 vehicles a day, roughly 12% of them trucks, projected to reach 5,101 by 2041. The structure is 279 ft (85 m) long and 49 ft wide. If it were closed, the detour would be 5.6 mi (9 km).

CarriesRTE 22
CrossesFactory Hill Road Wallo
Location0.2 MI S JCT Rts 67 & 22
RouteState Highway 22
Coordinates42.92674, -73.34421
Functional classRural Minor Arterial

Condition and inspection

Good

All primary components (deck, superstructure, substructure, or culvert) are rated 7 or higher. No significant problems were noted.

ComponentRatingMeaning
Deck9 ExcellentNo problems noted.
Superstructure9 ExcellentNo problems noted.
Substructure9 ExcellentNo problems noted.
Channel and channel protection7 GoodSome minor problems.
Last inspectionMay 2024
Inspection intervalevery 24 months
Operating statusOpen, no restriction
ScourFoundations stable; scour within limits of footing or piles
Structural evaluation9: Superior to present desirable criteria
Deck geometry6: Equal to present minimum criteria
Waterway adequacy8: Equal to present desirable criteria
Approach roadway alignment8: Equal to present desirable criteria
Operating rating82 US tons
Inventory rating49.1 US tons

Structure

MaterialSteel Continuous
DeckConcrete, cast-in-place
Main spans2
Design loadHL 93
Structure length279 ft (85 m)
Longest span154 ft (46.9 m)
Deck width49 ft (15 m)
Roadway width40 ft (12.2 m)
Vertical clearance over deckUnrestricted

Traffic and service

Average daily traffic4,783 (2018)
Projected traffic5,101 by 2041
Trucks12%
Lanes on structure2
Traffic directionTwo-way traffic
CarriesHighway and pedestrian
CrossesHighway and waterway
Detour if closed5.6 mi (9 km)
TollOn a free road
National Highway SystemNo

Ownership and planned work

OwnerState Highway Agency
Maintained byState Highway Agency
Historic statusNot eligible for the National Register of Historic Places
Work proposedWidening with deck rehabilitation or replacement
Estimated improvement cost$5.5 million (2024 estimate)
NavigationNo navigation control on waterway

Frequently asked questions

When was RTE 22 over Factory Hill Road Wallo built?

It was built in 2018, making it 7 years old in 2025.

What condition is RTE 22 over Factory Hill Road Wallo in?

The National Bridge Inventory rates it in good condition. All primary components (deck, superstructure, substructure, or culvert) are rated 7 or higher. No significant problems were noted. The last reported inspection was in May 2024.

How much traffic does RTE 22 over Factory Hill Road Wallo carry?

About 4,783 vehicles per day (2018 count), of which roughly 12% are trucks.

How long is RTE 22 over Factory Hill Road Wallo?

The structure is 279 ft (85 m) long with a longest span of 154 ft (46.9 m) and a deck 49 ft wide.

Who owns RTE 22 over Factory Hill Road Wallo?

It is owned by the State Highway Agency.