US Bridges

Sliker Hill Road over Conesus Inlet

Good

Livingston County, New York · 1.8 MI W of Conesus · Structure no. 000000003316500

Built
2006
19 years old
Condition
Good
inspected September 2024
Type
Stringer/Multi-beam or Girder
Steel
Length
69 ft
1 main span
Daily traffic
1,700
2020 count
Owner
County
County Highway Agency

About this bridge

Sliker Hill Road over Conesus Inlet is a steel stringer/multi-beam or girder carrying Sliker Hill Road over Conesus Inlet in Livingston County, New York. It was built in 2006, so it is 19 years old, younger than the New York average of 53 years.

The most recent inspection reported to the Federal Highway Administration rates it in good condition with a lowest component rating of 8 out of 9. All primary components (deck, superstructure, substructure, or culvert) are rated 7 or higher. No significant problems were noted.

It carries about 1,700 vehicles a day, roughly 5% of them trucks, projected to reach 1,773 by 2041. The structure is 69 ft (21 m) long and 37 ft wide. If it were closed, the detour would be 3.7 mi (6 km).

CarriesSliker Hill Road
CrossesConesus Inlet
Location1.8 MI W of Conesus
RouteCounty Highway 0
Coordinates42.71553, -77.71233
Functional classRural Major Collector

Condition and inspection

Good

All primary components (deck, superstructure, substructure, or culvert) are rated 7 or higher. No significant problems were noted.

ComponentRatingMeaning
Deck8 Very GoodNo problems noted.
Superstructure9 ExcellentNo problems noted.
Substructure9 ExcellentNo problems noted.
Channel and channel protection6 SatisfactoryStructural elements show some minor deterioration.
Last inspectionSeptember 2024
Inspection intervalevery 24 months
Operating statusOpen, no restriction
ScourFoundations stable; scour above top of footing
Structural evaluation9: Superior to present desirable criteria
Deck geometry5: Somewhat better than minimum adequacy to tolerate being left in place as is
Waterway adequacy6: Equal to present minimum criteria
Approach roadway alignment8: Equal to present desirable criteria
Operating rating110.1 US tons
Inventory rating66 US tons

Structure

MaterialSteel
DeckConcrete, cast-in-place
Main spans1
Design loadHS 25 or greater
Structure length69 ft (21 m)
Longest span67 ft (20.4 m)
Deck width37 ft (11.4 m)
Roadway width34 ft (10.3 m)
Vertical clearance over deckUnrestricted

Traffic and service

Average daily traffic1,700 (2020)
Projected traffic1,773 by 2041
Trucks5%
Lanes on structure2
Traffic directionTwo-way traffic
CarriesHighway
CrossesWaterway
Detour if closed3.7 mi (6 km)
TollOn a free road
National Highway SystemNo

Ownership and planned work

OwnerCounty Highway Agency
Maintained byCounty Highway Agency
Historic statusNot eligible for the National Register of Historic Places
Work proposedWidening with deck rehabilitation or replacement
Estimated improvement cost$1.2 million (2024 estimate)
NavigationNo navigation control on waterway

Frequently asked questions

When was Sliker Hill Road over Conesus Inlet built?

It was built in 2006, making it 19 years old in 2025.

What condition is Sliker Hill Road over Conesus Inlet in?

The National Bridge Inventory rates it in good condition. All primary components (deck, superstructure, substructure, or culvert) are rated 7 or higher. No significant problems were noted. The last reported inspection was in September 2024.

How much traffic does Sliker Hill Road over Conesus Inlet carry?

About 1,700 vehicles per day (2020 count), of which roughly 5% are trucks.

How long is Sliker Hill Road over Conesus Inlet?

The structure is 69 ft (21 m) long with a longest span of 67 ft (20.4 m) and a deck 37 ft wide.

Who owns Sliker Hill Road over Conesus Inlet?

It is owned by the County Highway Agency.