US Bridges

Maltby Road over Sandy Creek

PoorPosted for load

Jefferson County, New York · 4.0 MI SW of Rutland Cent · Structure no. 000000003338920

Built
1939
86 years old
Condition
Poor
inspected May 2024
Type
Girder and Floorbeam System
Steel
Length
57 ft
1 main span
Daily traffic
34
2021 count
Owner
County
County Highway Agency

About this bridge

Maltby Road over Sandy Creek is a steel girder and floorbeam system carrying Maltby Road over Sandy Creek in Jefferson County, New York. It was built in 1939, so it is 86 years old, older than the New York average of 53 years.

The most recent inspection reported to the Federal Highway Administration rates it in poor condition with a lowest component rating of 4 out of 9. The lowest-rated primary component is rated 4 or below, indicating advanced deterioration. Poor does not mean unsafe; such bridges are inspected more often and may carry load restrictions. Its operating status is: posted for load restriction.

It carries about 34 vehicles a day, roughly 7% of them trucks, projected to reach 48 by 2041. The structure is 57 ft (17.4 m) long and 20 ft wide. If it were closed, the detour would be 2.5 mi (4 km).

CarriesMaltby Road
CrossesSandy Creek
Location4.0 MI SW of Rutland Cent
Coordinates43.89104, -75.81342
Functional classRural Local

Condition and inspection

Poor

The lowest-rated primary component is rated 4 or below, indicating advanced deterioration. Poor does not mean unsafe; such bridges are inspected more often and may carry load restrictions.

ComponentRatingMeaning
Deck4 PoorAdvanced section loss, deterioration, spalling or scour.
Superstructure4 PoorAdvanced section loss, deterioration, spalling or scour.
Substructure5 FairAll primary structural elements are sound but may have minor section loss, cracking, spalling or scour.
Channel and channel protection7 GoodSome minor problems.
Last inspectionMay 2024
Inspection intervalevery 12 months
Operating statusPosted for load restriction
ScourFoundations stable; action required to protect exposed foundations
Structural evaluation4: Meets minimum tolerable limits to be left in place as is
Deck geometry4: Meets minimum tolerable limits to be left in place as is
Waterway adequacy4: Meets minimum tolerable limits to be left in place as is
Approach roadway alignment4: Meets minimum tolerable limits to be left in place as is
Operating rating35.1 US tons
Inventory rating21.1 US tons

Structure

MaterialSteel
DeckConcrete, cast-in-place
Main spans1
Design loadUnknown
Structure length57 ft (17.4 m)
Longest span51 ft (15.5 m)
Deck width20 ft (6.1 m)
Roadway width18 ft (5.5 m)
Vertical clearance over deckUnrestricted

Traffic and service

Average daily traffic34 (2021)
Projected traffic48 by 2041
Trucks7%
Lanes on structure1
Traffic directionOne-lane bridge for two-way traffic
CarriesHighway
CrossesWaterway
Detour if closed2.5 mi (4 km)
TollOn a free road
National Highway SystemNo

Ownership and planned work

OwnerCounty Highway Agency
Maintained byCounty Highway Agency
Historic statusNot eligible for the National Register of Historic Places
Work proposedWidening with deck rehabilitation or replacement
Estimated improvement cost$576,000 (2024 estimate)
NavigationNo navigation control on waterway

Frequently asked questions

When was Maltby Road over Sandy Creek built?

It was built in 1939, making it 86 years old in 2025.

What condition is Maltby Road over Sandy Creek in?

The National Bridge Inventory rates it in poor condition. The lowest-rated primary component is rated 4 or below, indicating advanced deterioration. Poor does not mean unsafe; such bridges are inspected more often and may carry load restrictions. The last reported inspection was in May 2024.

How much traffic does Maltby Road over Sandy Creek carry?

About 34 vehicles per day (2021 count), of which roughly 7% are trucks.

How long is Maltby Road over Sandy Creek?

The structure is 57 ft (17.4 m) long with a longest span of 51 ft (15.5 m) and a deck 20 ft wide.

Who owns Maltby Road over Sandy Creek?

It is owned by the County Highway Agency.